Hobs for worm gears
2021-11-09 11:27:25
jiangxingTools
2794
Hobs for worm gears
The flank form of a worm gear hob is determined by the flank form of the driving worm. The various flank forms are standardized in DIN3975, which distinguishes between ZA, ZN, ZI and ZK worms according to the generating method.
Worm gear hobs can be manufactured as bore-type hobs with keyway or drive slot, or as shank-type hobs. Generally, preference is given to the less expensive bore-type hobs. However, if the hob diameters are very small and the profiles very high, it may be necessary to select a shank type.
相關(guān)文章
-
Bohler S790 Microclean for Hobs
Bohler S790 Microclean for HobsMaterial composition of S790: C-1.29, Si-0.6, Mn-0.30, Cr-4.20, Mo-5,... - PA20° Standard Gear Milling Cutter with Module m1
- ?PA20° PCD 75mm Disk Type Gear Shaper Cutter with Module m1~m4
- The new cutting material of gear hobs-SpeedCore
- Timing Pulley Hob for S.T.D L(9.525)
- Worm Wheel Hob
- GB Standard Gear Hobs with M1-M10
